Contact us : [email protected]
Contact us : [email protected]
Tank Clean nozzle


It can form a linear needle-shaped liquid column flow under different pressure conditions and can withstand pressures up to 140 bar. The nozzle holes are made of ruby ​​and ceramic.


Under computer control, the workpiece can be carved arbitrarily, and is less affected by the texture of the material. Because of its low cost, easy operation, and high yield rate, waterjet cutting is gradually becoming the mainstream cutting method in industrial cutting technology. This basic principle is both simple and complex. The water jet starts from a pressurized pump, passes through a high-pressure pipe, and then emerges from the cutting nozzle. Very simple explanation. However, it has undergone a very complex design to produce a pressure of 60,000 PSI. During the design process, small leaks will permanently corrode the components and cause damage. So manufacturers and engineers carefully handle the processing of high-pressure materials and use special technologies to combine such machines. Users only need to know basic operating knowledge.

Nozzle thread
1/8 (1 point), 1/4 (2 points), 3/8 (3 points), 1/2 (4 points)
Multiple apertures available
0.4 hole, 0.6 hole, 0.8 hole, 1.0 hole, 1.2 hole, 1.5 hole
product material
The main body is made of brass and 303, 304, and 316 materials. The filter is made of stainless steel and is divided into two types: removable and non-removable. The nozzle holes are ceramic or gem inlays.

Suitable for

High-pressure cleaning, paper edge cutting, grooved roller cleaning, blind hole roller cleaning, press section felt high-pressure swing cleaning, long net high-pressure swing cleaning

Related technologies and products